Menu

Approved Vendor

Manufacturer & Exporter: Surfactant, Oilfield Chemicals, Cosmetic Waxes & Specialty Chemicals

Oil Soluble Demulsifier (Crude Oil Demulsifier)

Rimpro oil soluble demulsifier series is a totally organic liquid formulation of surfactants and dispersants in a water and soluble in toluene, Xylene, Aromatic solvent, crude oil for the demulsification of water in oil and oil in water, capable of performance at room temperature, but with improved speed and percentage of oil removed when applied at temperatures near 60 deg. C (140 deg. F). RIMPRO crude oil demulsifier destabilizes the oil-water interface that surrounds each water particle in the emulsion, replaces the emulsifier molecules (if any), and allows the water to coalesce. RIMPRO crude oil demulsifier (demulsification of crude oil) is a completely combustible, non-abrasive; non-ash-forming treatment, which will improve the quality of the fuel it, is added to. The effects of crude oil demulsifier in demulsification of water in crude oil emulsions are based on relative rates of water separation were recognized through emulsion breakers.



Characteristics of Oil Soluble Demulsifier : Homogenous Liquid Density - 0.9 +- 1.0 Solubility - Toluene, xylene, crude oil, aromatic solvent Ph range - 6.5 to 8.0 Water solubility - Dispersion & Insoluble



Advantages of Crude Oil Demulsifier: Stays with the fuel and actually improves burning characteristics of the fuel uses lower dosages than most competing products



Dosage of Crude Oil Demulsifier (Oil Soluble Demulsifier):
Because of the diverse nature of oil and waste amenable to treatment with RIMPRO crude oil demulsifier (demulsification of crude oil), specific recommendations have to be made on a case-by-case basis. The dosage of RIMPRO crude oil demulsifier prescribed to break a particular emulsion varies from as little as 1 gallon per 20,000 gallons (50 ppm) of oil to as much as 1 gallon per 10,000 gallons (100 ppm) of oil. A few clients have even found that 20 ppm was more effective than the higher dosages, so we suggest adding the lower levels to your laboratory bench tests to verify the correct dosage for the specific application. Finding the most cost-effective dosage, as well as determining the best conditions of temperature, slow mixing, settling time, etc., is best done in the laboratory, using a sample of the actual oil or waste and a sample of RIMPRO crude oil demulsifier



Application of Oil Soluble Demulsifier :
Once you have determined the correct dose of RIMPRO crude oil demulsifier, fill the tank with the waste-oil-water solution and inject the correct dose of RIMPRO oil soluble demulsifier for demulsification of crude oil, directly from the drum. Mix thoroughly, with the assistance of a pump, for two to five hours. Mixing time varies depending on the size of the tank and the speed of the motor. Allow the fuel to settle and check for water separation. Depending on the configuration of the tank, either remove the water by means of a drain in the bottom or suck the clean oil off from the top of the tank.